|Home||Products||Custom Hinges||About Us||Contact Us|
The length of the leaves measured parallel to the pin.
The overall dimension of leaves measured across the pin
The rod running the length of the hinge. The pin holds the leaves of the hinge together.
The hollow circular part at the joint of the hinge through which a pin is passed.
The dimension of the knuckle measured parallel to the pin.
The dimension between the outer face of the knuckle and the opposing edge of the leaf cut-out over the entire range of rotation.
The dimension from the centre of the pin to the outer edge of the leaf.
The amount of axial movement between leaves.
Leaves stay flat in the same plane in a open position.
Opposing leaves extend laterally from opposite sides of the pin in the open position. Leaves will not close to parallel position.
One leaf is a different width than the other, measured from the centre of the pin.
One Leaf Half Swaged
Leaves stay flat in the same plane in an open position.
Both Leaves Half Swaged
Both leaves swaged approximately one half the pin diameter.
One Leaf Fully Swaged
One leaf swaged equal to the pin diameter and both leaves parallel when in closed position.
One Leaf Reversed Swaged
One leaf swaged to simulate reversed assembly. Leaves will not close to parallel position.
Forming of one or both leaves to provide more clearance between the leaves in closed position.